The steering column arrived after the car and as I mentioned in an earlier note I have to cut and mount. The issue I’m running into is steering rack location/position. If I mount higher up 4” below firewall weld the tie rods go through the upper opening(which I believe is correct) but the tie rods rest on the aluminum sides, bottom of cut out even if I mount to the upper side on the wheel versus bottom mount. If I go low and use the lower cutout, it will rub over a bump.
Any finished photos showing the mount location would be greatly appreciated. Also, any advice to make it easier would be great.
I have the car stripped down to the frame, so
I have room to work.
Thank You
Bill
Any finished photos showing the mount location would be greatly appreciated. Also, any advice to make it easier would be great.
I have the car stripped down to the frame, so
I have room to work.
Thank You
Bill