Thx much. Unfortunately, the largest OD McMaster/Carr have is too big and the next size smaller is too small. I wonder what others have been using. My guess is that RCR turned the ones shown in the online manual. I see a lathe in my future :)
Brian,
That is an awesome looking induction system. Is your Lola build inspired by any of the Can Am cars or are you doing a Kissel interpretation?
I am still trying to decide. Leaning towards the Borla 8-Stack from Prestige because it looks period correct.
Cheers, Randy
For sure RCR is just as interested in shipping your car as you are, if not more so. The cars take up valuable space and tie up funds that could be used for something else. My understanding is they are incredibly busy with many cars in the almost ready to ship state and are probably prioritizing...
I spent the past few days deburring the tub and the many aluminum pieces. It took a more time than it should have because I pretty much polished the edges. A complete waste of time, but I couldn’t resist using my newly acquired pneumatic die grinder to it’s fullest extent and I just really like...
I have two sets of SBF engine mounts. One set is from Prothan (same as Sean’s above except they are red and silver), the other (black and gold) is from Energy Suspension. Fitment is identical. I can return the Prothans so wondering if I should. Thx in advance. Cheers, Randy
Randy, Thx much. Given the heat sink mass of the chassis, preheating to 200F makes sense. These welds are only going to be tack welds and the patch is not structural so all I need is a little penetration to hold the plug and allow for grinding the tacks flush with chassis. I am going to get a...
Bill, thx for the guidance. To avoid heat build up, I plan on doing a series of tack welds and the welds don’t need much penetration since the patch is cosmetic. Cheers, Randy
I am planning to MIG with the spool gun. An AC welder is out of my price range. I did find this about TIG welding aluminum with DC, but that level of expertise is way out of my league.
https://forum.weldingtipsandtricks.com/viewtopic.php?t=2002