Howard Jones's latest activity
-
Howard Jones replied to the thread Race Car Replica's GT40 MKIV Sale.Yes, it was. I saw it there also. I think it is the best car done by RCR. Although.................... there was a 917 I stared at for... -
Howard Jones replied to the thread SLC Superlite: All In Cost Spreadsheet.When you buy a Tranaxle....... Well, here is what not to do. Don't buy a used transaxle that is " low miles, shifts fine, no problems"...
-
Howard Jones replied to the thread RCR40 Upper Control Arm Ball Joint (Tie Rod End) Source.Do you think this will work? It relocates the grease fitting to the top. I think it is the same otherwise but you should check...
-
Howard Jones replied to the thread SLC Superlite Cost Spreadsheet- Itemized/All In Costs.Chris, It would be MUCH simpler for you to tell us what your budget is. I would be happy to comment on that. Otherwise, it's between...
-
Howard Jones replied to the thread SLC 24 Howard Jones.It's all hard-mounted. Nothing really moves around. The other thing is that hard-line is 1/2 diameter and very stout. But you got me...
-
Howard Jones replied to the thread Bryan's RCR40.Far more important if this is a street car that will get driven on the highway for moderate to long distances. What you would be most...
-
Howard Jones replied to the thread SLC 24 Howard Jones.I finished the surge tank. The hoses were challenging to route in a way that they could be removed easily. I did one hard line because...
-
-
Howard Jones replied to the thread New for SPF- Vent/"Toll" window seal kit.I wonder if this would work https://www.amazon.com/Trisiki-Transparent-Winterized-Stripping-Waterproof/dp/B0CTLT97RX
-
Howard Jones replied to the thread Radiator Cooling Fans.Ya, I think you are OK. Especially if the fans run well for the next few outings and do not fail. What you want to watch for is that...
-
Howard Jones replied to the thread Fan and Water Pump Controller.Chris, Where is the controller located? In the engine room or in the cockpit? I suspect they won't like engine room heat. Mine is...
-
Howard Jones replied to the thread Radiator Cooling Fans.Just to get you started. The pigtails that come out of the fans are the gauge of wire that we must assume is adequate. Since there are...
-
-
Howard Jones replied to the thread Has anyone tried one of those electric boost power brake setups?.Jeff the master cylinder bore on that is 1 3/16s. That is much larger than the typical master cylinder sizes I have in my car F=0.7 R=...
-
Howard Jones replied to the thread SLC 24 Howard Jones.Robert, they were Radicals. Some have 1350cc motors that make about 180-190HP and the 1500cc engines make 200-225HP, the older models...
-
Howard Jones replied to the thread SLC 24 Howard Jones.I do have a fuel level gauge in the main tank. It is one of the capacitive probe types. It does work but it is slow to react, If I start...
-
Howard Jones replied to the thread Steve's RCR GT40 Build.I was thinking you might want to add a "grill" to that pannel to ventilate that area. The MSD will use about 6-8 amps or about 75 -100...
